News Office Field Order Support About Us

Re: Planting map

Search Discussion Boards
May 10, 2012 06:14PM
Shirley,

When you right click on the Imported Job and select Job Properties (or just Properties from the Jobs tab), do you see the different varieties supply names planted to field?

We can manually edit the Variety layer as well, I was just trying to figure out why the Variety map legend does not show the different Variety supply names.

Here are the steps to Edit the Variety Map:

1. Display Variety map as top layer.
2. Click the green pencil (Edit layer) button.
3. Use the Split Line Tool or if you know the exact width of the 12 row section of planter you can use the Buffer Tool setting up the planter sections. Remember the first buffer line will be for the 12 row width and then after will be width for the 24 rows (because of the turn arounds)
4. Once all the planting strips have been created go back to the Select Tool (pointer tool)
5. Hold Down on the CTRL key and left click on all the areas that have the same variety planted.
6. Right click and select Properties.
7. Click into the emply box for the Variety, which will give a drop down arrow. Select correct Seed Variety supply name and OK.
8. Repeat steps 5-6-7 for the other sections.
9. Click Save and Close when finished defining all the areas.

Hope this helps!

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

Planting map

Shirley MaschoffMay 10, 2012 10:31AM

Re: Planting map

KathyClineMay 10, 2012 10:42AM

Re: Planting map

Shirley MaschoffMay 10, 2012 03:54PM

Re: Planting map

KathyClineMay 10, 2012 06:14PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited