I am assuming you are using SiteMate VRA or FW Mobile to connect with this controller. If this is the case, you need to make connection with the controler within our Software. Go to the Config Tab (wrench). Go to Settings and then VRA Setup. Select New. Type a description such as Amazone. Then you select the Amazone Amatron+ (I believe this should be your option based upon previous post). Leave the comport to 1 if connected to the serial port on Nomad. The Baud Rate should not be an issue. The Map tab will help with matching the Map rates to the controller rates. If both are setup the same then leave the defaults unchanged. The Applicator tab wants to know the time it takes for the communication from GPS rate to the controller for the Feed Delay. The Following Distance is the length between where the product is being applied to the GPS Receiver. The Swath Width is the application Width. Make the correct selection for the Controller Tab, matching firmware version running on the controller and the type of application, if using the newer version. Tap OK. Once the VRA Job has been setup, then tapping Go will start the application map, logging the as applied rate.
Hope this makes sense.
Thanks,
Kathy Cline,
Farm Works Software
