News Office Field Order Support Contact Us

Fmx lines exported to Pro600/700

Search Discussion Boards
May 05, 2014 07:29AM
I have mapped paddocks with an fmx using headland pattern. i need to export these lines to pro600 for controlled traffic. The only way i have managed so far is to offset the line to half the sprayer width which is 18m off of the boundary. If i export them like this the pro 600 won't load them because the some curves are to tight and the minimum turn radius cant be put to 0. So i have had to move all the points on corners and smooth them off. This is a very time consuming way to do this. Please tell me if there is an easier way.


Fmx lines exported to Pro600/700

ajaxMay 05, 2014 07:29AM

Re: Fmx lines exported to Pro600/700

Kathy ClineMay 05, 2014 09:24AM

Sorry, you do not have permission to post/reply in this forum.
Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited