News Office Field Order Support Contact Us

Re: Kenai GPS correction possible

Search Discussion Boards
November 02, 2016 12:58PM
When looking at specification of Trimble Kenai, it stands that is gps reciever is capable of correctiong the signal with RTCM 2.3 correction source.
"Supports real-time DGPS: RTCM v2.3"

>>Correct the internal GPS element inside the Kenai can support DGPS correction service information such as SBAS and RTCM.(RTCM 2.3)

How can I use that? Will I need other Trimble software to send rtcm to the antenna?

>>RTCM corrections can be applied by streaming Type messages into the Keani - they can be supplied by a variety of means via radio or directly from a GNSS receiver. Market applicable Field Software will support the port controls and some level of software programming may be needed. To be clear, the Farm Works Mobile software will not support this.

Kenai would typically use the following RTCM 2.3 message types, if supplied

>>Alternatively SBAS signals, which provide similar DGPS correction results can be supplied with no additional antenna necessary - SBAS Satellites must be in view and the Kenai GNSS app on the desktop can be used to verify if SBAS has been switched on (note that an external can be supported only when using the Keani Vehicle Dock [trimblemcs.com]
SubjectAuthorPosted

Kenai GPS correction possible

MichalPOctober 31, 2016 08:11AM

Re: Kenai GPS correction possible

KathyClineOctober 31, 2016 08:32AM

Re: Kenai GPS correction possible

Michał PrądzyńskiOctober 31, 2016 11:08AM

Re: Kenai GPS correction possible

Scott NusbaumNovember 02, 2016 12:58PM

Re: Kenai GPS correction possible

KathyClineOctober 31, 2016 02:53PM

Re: Kenai GPS correction possible

Michał PrądzyńskiDecember 15, 2016 09:13AM

Re: Kenai GPS correction possible

KathyClineDecember 15, 2016 12:46PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited