News Office Field Order Support Contact Us

November 14, 2011 12:28PM
When syching desktop to USB and then take to the Yuma, I would go into Windows Explore. Open drive reading the USB, tap and hold on the TMSMData folder and select Cut. Go to the Yuma's C:Drive, tap and hold on Drive Letter and select Paste. Answer Yes to replace (ONLY) when we know the Yuma, does not have current data ready to take back to the USB. Open Mobile. Go to the Config Tab - (wrench) - Resources- Projects. Make sure the data folder is looking at the C:Drive which will have the most current TMSMData folder/Project name with edited boundaries.

After data has been entered in Mobile and we need to take back to USB, go back to Windows Explore on the Yuma. Open the C:Drive and tap and hold on the TMSMData folder and select Cut. Then locate drive reading the USB, Tap and hold and select Paste.

By doing the cut process, in future you will not need to replace the old TMSMData.

Hope this makes sense.

Thanks,

Kathy Cline,
Trimble Ag Software Support
For fast replies email: TABS_Support@trimble.com
SubjectAuthorPosted

Yuma

JanineNovember 14, 2011 09:16AM

Re: Yuma

Kathy ClineNovember 14, 2011 12:28PM



Sorry, you do not have permission to post/reply in this forum.
Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited