News Office Field Order Support Contact Us

Re: Yuma and GreenSeeker

Search Discussion Boards
April 25, 2011 03:34PM
If you are planning to use the Internal GPS of the Yuma, you should be able to connect the Green Seeker to the RS232 9-pin serial port on the Yuma.

From FW Mobile 2011.3, go to the Config Tab - Wrench. Open Logging and then Device Setup. Tap New. Enter a description for the Geen Seeker Device. Select the Green Seeker for the Type. Select Com 1 for the port. Select the Device Tab. This is where you match the Settings within FW Mobile to the firmware that is running on the Green Seeker. Tap OK when completed.

Then you are ready to start a New Sensor Job for logging data from the Green Seeker.

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

Yuma and GreenSeeker

Brady AdamsApril 20, 2011 10:44PM

Re: Yuma and GreenSeeker

KathyClineApril 21, 2011 10:24AM

Re: Yuma and GreenSeeker

Brady AdamsApril 21, 2011 04:28PM

Re: Yuma and GreenSeeker

KathyClineApril 22, 2011 08:46AM

Re: Yuma and GreenSeeker

Brady AdamsApril 22, 2011 10:27AM

Re: Yuma and GreenSeeker

KathyClineApril 22, 2011 11:28AM

Re: Yuma and GreenSeeker

Brady AdamsApril 22, 2011 09:20PM

Re: Yuma and GreenSeeker

KathyClineApril 25, 2011 03:34PM

Re: Yuma and GreenSeeker

Paul RaymerApril 26, 2011 09:28AM

Re: Yuma and GreenSeeker

Brady AdamsApril 26, 2011 11:37AM

Re: Yuma and GreenSeeker

Paul RaymerSeptember 05, 2011 08:26PM

Re: Yuma and GreenSeeker

Paul RaymerApril 26, 2011 01:09PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited