June 25, 2018 01:11PM
Hi. I'll post this again. Seems like it disappeared.
I would like to add a few points to the topographic layer in Subsurface. Is this possible? I have areas that are only one point wide so I can't draw a drainage ditch through it because there is no topographic layer. I'd like to add points offset about 10' from the original points using the same elevation. How can I do this?
Thanks.
SubjectAuthorPosted

Add topo points

Dave BrotenJune 25, 2018 01:11PM

Re: Add topo points

Scott NusbaumJune 28, 2018 09:09AM



Sorry, you do not have permission to post/reply in this forum.