April 07, 2017 10:40AM
No. The boundary layer is always the default layer. After you clicked Save and Close. Go to the Layers tab found beneath the Mapping screen at bottom. From the Displayed box you will see the Boundary layer. Go to the next box called View and make sure the Field Boundaries option is highlighted. Then under the Red Barn tab, open the client and Farm and highlight the field name again. Now go to the Mapping screen and verify you see the boundary map you just imported. You can also check the Transparency slide bar in lower right hand to verify it is slide to the right.

Hope this helps!

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

Export boundary and import to new job

Dave BrotenApril 03, 2017 05:55PM

Re: Export boundary and import to new job

KathyClineApril 03, 2017 06:50PM

Re: Export boundary and import to new job

Dave BrotenApril 06, 2017 11:33AM

Re: Export boundary and import to new job

KathyClineApril 07, 2017 10:40AM



Sorry, only registered users may post in this forum.

Click here to login