News Office Field Order Support Contact Us

Creating topographic layer

Search Discussion Boards
August 16, 2016 03:21PM
Hi.

I've been using some Lidar elevation data into Surface to use for preliminary tile planning. When I go into layer properties there are two layers. Point number and Z (I change the definition of Z to Elevation). Can I delete the point numbers in the layer? I'm hoping this might speed up the processing of that layer into a topographic layer. There are usually a few hundred thousand elevation points to deal with.

Thanks.
SubjectAuthorPosted

Creating topographic layer

Dave BrotenAugust 16, 2016 03:21PM

Re: Creating topographic layer

KathyClineAugust 17, 2016 01:31PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited