September 24, 2015 02:45PM
Just as a side note, you can also add to the Map Data display to show the Rate and As Applied numbers on the screen to verify you have communication. Here are the steps to follow:

1. Select the Config (wrench) Tab.
2. Open the Display button.
3. Select the Map Data Display.
4. From the Map Display List screen select the drop down arrow in the Display Templates box.
5. Select Sensor, if NOT loading a VRA Rate map for control, or select VRA is using a rate map.
6. There will be 6 button choices. Which ever button you select will determine where the options will display on the right side of the Screen.
7. Select desired placement button.
8. For Sensor only select this options and select the appropriate controller rate option. OK Repeat for other options
9. For VRA options open and select the Applied Rate and OK. Repeat for the second button to VRA and select the Target. OK
10. This will give you the information to make sure the rates out (VRA control) or As Applied rates coming back from the controller to verify if proper communication out and in is correct.

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

DJ Land Manager II

colincameron49September 22, 2015 06:35PM

Re: DJ Land Manager II

KathyClineOctober 05, 2015 03:19PM

Re: DJ Land Manager II

KathyClineSeptember 24, 2015 08:06AM

Re: DJ Land Manager II

colincameron49October 05, 2015 03:06PM

Re: DJ Land Manager II

KathyClineSeptember 24, 2015 02:45PM



Sorry, only registered users may post in this forum.

Click here to login