News Office Field Order Support Contact Us

Re: Farm Works logs random line

Search Discussion Boards
June 20, 2013 07:56AM
It sounds as though you have lost GPS signal even for a short temporary period, which cause the path line to shoot a line to 0.00 Lat and 0.00 Long with is off the coast of Africa (South west) then when signal has been regained the path goes back to normal location. I would start out by trying to figure out why we could be lossing GPS signal. However, there is a setting in Site mate and Mobile to stop that line from logging that far away.

1. Go to the Config Tab (wrench) and select Settings
2. Open the GPS settings
3. Select the Quality Tab
4. Check the box called Maximum HDOP and enter a small number such as 25.
5. Tap OK

This will not help with keeping GPS signal - but will stop logging path after reaching this Max. HDOP of 25.

This job/mapping layer can be edited in FW Office which has the trouble with the unwanted line using the Split Line tool and deleting the unwanted portion of line that logs to the 0 lat/log and back.

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

Farm Works logs random line

mightymatt40June 19, 2013 11:11AM

Re: Farm Works logs random line

KathyClineJune 20, 2013 07:56AM

Re: Farm Works logs random line

mightymatt40July 31, 2013 10:49AM

Re: Farm Works logs random line

KathyClineJuly 31, 2013 02:10PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited