News Office Field Order Support Contact Us

Interface switch

Search Discussion Boards
March 11, 2009 04:34PM
I was in the process of switching planter tractor a few days back which required moving all the wiring that I had done. Well know that I got everything in I can't get my IFB or IFB2 box to work (not sure which one it is). I have tried every possible combination and nothing works, so I'm hopin if I buy your new interface switch if that would help narrow down the confusion with wiring it up.

Here is what I want I"m getting gps off of an EZ-guide 500 with ez steer this year instead of my raven 115 receiver, But I also want to be able to log planting varities using site mate and trac mate, Would it be as simple as pulling a signal from my 500 through the interface switch to my ipaq, and log varities? with the red wire tied into a powered wisker switch? Will this work or not? I can get a signal from my 500 to my ipaq but not sure if it will work goin through an interface switch.

I hope this makes sense. cuz I'm ready to throw my old IFB in the trash, I couldn't get anything to work.

thanx Brad
SubjectAuthorPosted

Interface switch

brad23March 11, 2009 04:34PM

Re: Interface switch

KathyClineMarch 11, 2009 05:55PM

Re: Interface switch

Scott NusbaumMarch 12, 2009 08:56AM

Re: Interface switch

brad23March 12, 2009 09:41AM

Re: Interface switch

Scott NusbaumMarch 12, 2009 12:23PM



Sorry, only registered users may post in this forum.

Click here to login

Privacy Statement | Terms of Use | Copyright 2009, Trimble Navigation Limited