April 12, 2016 10:09AM
Unfortunately, planned jobs without layers cannot be used on the FMX. Just the Resource list information will be placed into a Data Dictionary folder. When that data is transferred to the FMX, after getting past the configuration windows when the event has been established you will still need to select the Event Attribute button. The FMX will be limited to one supply so you can open Material and select the desired supply. There are also other selections from the same Event Attribute for the Crop and equipment etc. The data you select from the Event Attribute button will be the data found in the completed job you read into Farm Works.

Now if you are using the Field IQ unlock, on the FMX - you can Create a Planned VRA job that shows the rates of different supplies that can be used for rate control, but you should still setup the event and use the Event Attribute button to get your Job Properties correct when reading into FW. If you do use multiple supplies then more may need to be added manually after job has been read into Farm Works. Right click on the imported Job and select Properties from the Jobs Tab. When the Farming box displays - click the Add Menu and select Inputs. Open Supplies and correct Supply Type heading. Highlight the extra supply used in the field and click OK. Repeat until all missing supplies are added. Then can enter the rate or total qty used for the field.

Thanks,

Kathy Cline,
Farm Works Software
SubjectAuthorPosted

Uploading a Job to the FMX

Paul CampbellApril 11, 2016 03:29PM

Re: Uploading a Job to the FMX

KathyClineApril 12, 2016 10:09AM

Re: Uploading a Job to the FMX

Paul CampbellApril 12, 2016 04:11PM

Re: Uploading a Job to the FMX

LeslieApril 12, 2016 09:17AM

Re: Uploading a Job to the FMX

Paul CampbellApril 12, 2016 09:33AM

Re: Uploading a Job to the FMX

LeslieApril 13, 2016 06:50AM



Sorry, only registered users may post in this forum.

Click here to login